CNC TB6560 4 Axis Stepper Motor Driver Board Kit USB Breakout Card Power Supply
CNC 4 Axis Stepper Motor 1.2N. M+TB6560 Driver+USB Breakout Board+250W Power. HY-DIV168N-3.5A subdivision-type two-phase hybrid stepping motor drive using DC 12 36V power supply. Two-phase hybrid stepping motor dynamic voltage 12 to 36V, the current is less than 3.5A outer diameter of 35 to 86 mm. This drive using the drive's current loop subdivision control, the motor torque ripple is very small, low-speed running is very smooth, almost no vibration and noise.
High-speed torque is much higher than other two-phase drive, high positioning accuracy. Widely used in the engraving, CNC, packaging machinery and other high resolution requirements on the device. Average current control, two-phase sinusoidal current drive output.
DC 12 36V power supply, the internal integration of 12V and 5V regulator. Optically isolated signal input / output. Overvoltage, undervoltage, overcurrent, and white short-circuit protection. 4 file segmentation and automatic half-streaming capabilities up to 16 segments.
File output phase current settings. High starting speed + high-speed torque Electrical parameters.
Input voltage DC 12 36V input. The input current of 1 to 4 amps, select the drive a stepper motor. Output current of 0.5A 3.5A.
Temperature Operating Temperature -10 to 45? Humidity not condensing, not drops. Gas prohibit combustible gas and conductive dust. Step Angle Accuracy: +-5%(full step, no load). Resistance Accuracy: +-10%- Inductance Accuracy: +-20%.Temperature Rise: 80 Degrees Celsius CMax. (ratod current, 2 phase on)- Ambient Temperature: -10°C-+50°C. Dielectric Strength: 500V AC for one minute. Shaft Radial Play: 0.06Max.
Shaft Axial Play: 0.08Max. Black: A+ Green: A- Red: B+ Blue: B. CNC USB Interface Breakout Board.
Features: 1: The maximum matching 5-axis stepper motor driver 2: The two-stage signal processing, signal transmission smooth, powerful anti-jamming 3:5 input interface to define the emergency stop, limit, points in the knife, etc. 4: relay output control interface, can be accessed by the spindle motor or the air pump, water pump, etc 5: five-axis job LED display, visual display products, working condition. Input Power:5V DC power supply or computer USB to take power. Work axis stepper:Received the highest 5-axis independent driving. Drive:Pulse + direction + enable signal. AC Input: 115VAC 5.5A 230VAC 3.5A 50/60Hz. Note: 110/220V is selected by swith before power on. Please check input voltage to avoid damage! 1 x USB CNC breakout board.4 x TB6560 3.5A stepper motor driver. 4 x Stepper Motor 57BYGH56-401A.
1 x 250W 24V 10A power supply. ECheque will be held until cleared. This item is ALL BRAND NEW and in the original factory box and packing, All products have been checked and packaged in good condition before dispatch. We will give you a return ID. Meanwhile Please tell us what the defect is, to eliminate improper use. The item "CNC TB6560 4 Axis Stepper Motor Driver Board Kit USB Breakout Card Power Supply" is in sale since Thursday, May 24, 2018. This item is in the category "Business, Office & Industrial\Industrial Automation & Motion Controls\Other Automation Equipment". The seller is "gold-bucket" and is located in Shenzhen. This item can be shipped worldwide.- Brand: HY
- MPN: Gold-ZM000264
- Country/Region of Manufacture: China