1 pc Power Supply 350Watts(24VDC/14.6A). Toshiba TB6560AHQ chip - High power, maximum 3.5Adrive current chipset. Higher accuracy and smoother operation than standard 1, 1/2 step. Adjustable drive current settings for each axis - 25%, 50%, 75%, 100% of full current can be set for different stepper motors. Overload, over-current and over-temperature safety.Full protection for your computer and peripheral equipment. Power output can be set according to specific user requirement. Full closed-type optical isolation to protect the user's computer and equipment. 36V 7.5A for spindle motors or coolant pump (only one device can be powered by this output).
4 channel inputs interface- Can be used for XYZ limit and emergency stop. Professional design - Two stage signal processing with super anti-jamming. Bipolar constant current chopper drive with non-resonant region - Controls motors smoothly through range without creep effect. Four control inputs (divided into pairs of knives). Allows setting of limit and emergency stop.
Supports most parallel software MACH3, KCAM4, EMC2 etc. 12-16V DC power supply for Nema 17 stepper motors. 16-24V DC power supply for Nema 23 stepper motors. 24-36V DC power supply for Nema 34 stepper motors.High voltage will burn up the chips or stepper motors!!! Output current of the power supply can be calculated by the following expressions. Output current = Rated current of your stepper motors quantity + 2A. For example, if you want to drive 3 3A Nema 23 stepper motors, theoretically 24V 11A DC power. Supply is recommended, but higher power such as 24V 15A also will be good.
The power output of12V shall be applied to the radiator fan of 12V. Driver output compatible with 2 or4 phase, 4,6 or 8 lead stepper motors, 3A max. Suitable for unipolar or bipolar stepper motors. Voltage regulated spindle speed controlled by parallel interface as function of supply voltage.First, make sure that the motor wiring connection is right. Axis driver card must be set up according to the requirements of our product manual. Ou must use the XP system desktop computer and. Can only use the parallel conversion card. Need to use mach3 software. The power is 350Watts, and output voltage is 24VDC, and the output current is 14.6A. The item "3Axis Nema23 Stepper Motor 1.9N. M=270oz-in 3A&3Axis Driver Board TB6560 CNC KIT" is in sale since Friday, March 15, 2019. This item is in the category "Business, Office & Industrial\Industrial Automation & Motion Controls\Electric Motors\Stepper Motors". The seller is "longsmotor" and is located in Denmark.
This item can be shipped worldwide.